Hunter Fan 42814-01 warranty Wiring the Fan, qualified electrician, Dual Switch Wiring

	4 •Wiring the Fan
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.
4-1. Before attempting installation, make sure the power is still off.
4-2.	To connect the wires, hold the bare metal leads together and place
	a wire nut over them, then twist clockwise until tight. For all these
	connections use the wire nuts provided.
4-3.	Connect the bare or green ground wire (grounded) from the
	ceiling to the green ground wire (grounded) from the ceiling plate
	and the green ground wire from the fan.
4-4.	Connect the white wire (ungrounded) from the ceiling to the
	white wire (ungrounded) from the fan.
4-5.	Connect the remaining wires as follows:	Wire
	Dual Switch Wiring:
		Connector

• The black wire (ungrounded) from the ceiling to the black wire (ungrounded) from the fan

• The black/white wire (ungrounded) from the fan to the wire (ungrounded) for the wall switch

Single Switch Wiring:

• The black wire (ungrounded) from the ceiling to the black (ungrounded) and the black/white wire (ungrounded) from the fan

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

4-6. Turn the splices upward and push them carefully back through the ceiling plate into the outlet box.

4-7. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.



42814-01 • 06/18/07 • Hunter Fan Company