Read This Before Installing Thermostat

IMPORTANT

1Read the entire installation section of this Owner’s Manual thoroughly before you begin

to install or operate your Hunter Thermostat.

•Remove the mylar label from the display window.

INSTALLATION

2All installation is normally performed at your thermostat.

PROGRAMMING

3You can practice programming before installing your thermostat by inserting and

connecting the batteries and following the instructions on page 14. This can be done while you relax in your favorite chair and is a very good way to familiarize yourself with all the functions of your Hunter Thermostat.

OPERATION

4Your Hunter Thermostat is designed to operate with most gas, oil, electric or 2-wire

hot water heating, and air conditioning systems that have 24-volt or millivolt control.

This Hunter Thermostat will not control multistage heating or cooling systems, 110/220 V systems, or 3 wire zone systems.

COMPRESSOR PROTECTION

5The thermostat provides a 4-minute delay after shutting off the compressor before it

can be restarted. This feature will prevent damage to your air conditioner compressor caused by rapid cycling. It does not provide a delay when there are power outages.