Base Assembly
Stand Fan
1.Slide the Telescope Rod (7) into the top of the Stand Base (8) of the stand fan. The pole is notched so it will only fit into the base 1 way. Figure 7.
2.Secure the Telescope Rod (7) by screwing the Base Nut (9) onto it from underneath the base. Figure 8.
3.Slide the Fan Assembly onto the telescope pole of the base until it rests on the top of the pole. Figure 9.
4.tighten the screw on the back of the fan Assembly until secure.
Warning: Do not force pole into the Stand Base as damage to the Telescope Pole may occur. Do not overtighten the Base Nut or screws.
Height Adjustment
1.Grip the upper part of the telescope pole and loosen the Adjustment Knob.
2.Raise or lower the pole to the desired height.
3.Turn the Adjustment Knob until it is secure.
(7) Telescope Pole |
(8) Stand Base |
Figure 7.
(9) Base Nut
Figure 8.
screw |
Figure 9.
©2009 Hunter Fan Co. | 6 |
