Motor Assembly
1.Grasp the Telescope Pole firmly and twist the Adjustment Knob Counter Clockwise to loosen. Figure 7.
2.Raise the Inner Pole and tighten the Adjustment Knob by twisting Clockwise until secure.
3.Set the Motor(5) on top of the Pole(3), Figure 8., and Secure using the Motor Bolt(6) and Knob(7). Figure 9.
Note: The Motor Bolt has a square cut on the inside of the head, ensure this fits securely into the square hole in the Pole. Do not overtighten the Motor Knob, as this could make it difficult to tilt the motor later.
After securing the motor(5), Screw in the Tilt Adjustment Knob(8) securely. Figure 10. This Knob allows you to adjust the fans angle.
Figure 7.
(5) Motor
(3) Telescope
Pole
Figure 8.
(7) Motor
Knob
(6) Motor
Bolt
Figure 9.
(8)Tilt Adjustment Knob
Figure 10.
©2009 Hunter Fan Co. | 7 |
