Hunter Fan 45051-01, Type 7 Assembling and Hanging the Fan, Go to 4 Wiring the Fan

3 • Assembling and Hanging the Fan

You can assemble your fan for standard or angled mounting as shown in steps 3-1 – 3-3. For low profile mounting (ceilings less than 8 feet high), go to steps 3-6 – 3-9 on the next page.

3-1. To assemble fan to hang down from a flat or angled ceiling, place the canopy and canopy trim ring around the adapter so that they rest on the fan assembly.

3-2. Feed the wires from the fan through the downrod.

Note: Make sure all the wires are on the same side of the metal dowel pin inside the downrod.

3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers.

CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

WARNING: Do not carry or lift fan by canopy.

3-4. Raise the fan and place the ball into the hanger bracket.

3-5. Align the notch on the ball with the indent in the hanger bracket. (Rotate the fan until you hear the notch pop into place.)

Go to 4 • Wiring the Fan..

WARNING: Fan may fall if not assembled as directed in these installation instructions.

Steps 3-1 – 3-3
	Downrod
		Canopy
		Canopy
		Trim
Adapter		Ring
	Set Screw

Indent

Steps 3-4 – 3-5

Install Bracket & Wiring

6

45051-01 • 03/16/09 • Hunter Fan Company