English – 19
Maintenance schedule
The following is a list of the maintenance which should be conducted on the machine. For the items which
are not described in these instructions go to an authorised service workshop.
Check the engine’s oil level 21 ●
Check the engine’s cooling air inlet 21 ●
Check the fuel pump’s air filter 21 ●
Check the steering wires 22 ●
Check the brakes 23 ●
Check the battery 24 ●
Check the safety system 24 ●
Check screws and nuts – ❍
Check for fuel and oil leakage – ❍
Clean the air filter’s pre-filter (foam plastic) 2) 25 ●
Check the cutting unit 26 ●
Check the tyre pressures (60 kPa) 28 ●
Change the engine oil 1) 29 ●
Adjust the brakes – Rider 11 23 ●
Check the V-belts – ❍
Check the hydrostat’s cooling fins – Rider 13 H – ❍
Check the transmission’s oil level 24 ●
Adjust the brakes – Rider 13 H 23 ●
Lubricate joints and shafts 3) 29 ●
Check and adjust the throttle wire 31 ●
Clean the engine’s and hydrostat’s cooling flanges 2,4) –❍
Replace the air filter’s pre-filter and paper filter 2) 25 ●
Replace the fuel filter 31 ●
Replace the plug – ❍
1) First change after 5 hours. 2) During dusty conditions cleaning and replacement should be more frequent. 3) For daily use of the
machine lubrication should be conducted twice a week. 4) Conducted by authorised service workshop.
!WARNING!
No service procedures must be conducted on the engine or cutting unit unless:
• The engine is switched off.
• The ignition key is removed.
• The ignition cable is removed from the plug.
•The parking brake is applied.
•The cutting unit is disengaged.
Maintenance
Daily
mainte-
nance
before start
●= Described in these instructions.
❍= Not described in these instructions.
5025 100
MAINTENANCE
Page
Maintenance interval
in hours