OPERATION

TO START ENGINE

•Be sure fuel shut-off valve is in the “OPEN” position.

Your snow thrower engine is equipped with both a 120 Volt A.C. electric starter and a recoil starter. The electric starter is equipped with a three-wire power cord and plug and is designed to operate on 120 Volt A.C. household current.

•Be sure your house is a 120 Volt A.C. three-wire grounded system. If you are uncertain, consult a licensed electrician.

WARNING: Do not use the electric starter if your house is not a 120 Volt A.C. three-wire grounded system. Seri- ous personal injury or damage to your snow thrower could result.

COLD START - ELECTRIC STARTER

1.Insert safety ignition key (tied to recoil start cord) into ignition slot until it clicks. DO NOT turn the key. Keep the extra safety ignition key in a safe place.

2.Place throttle control in “FAST” position.

3.Rotate choke control to “FULL” position.

4.Connect the power cord to the engine.

5.Plug the other end of the power cord into a three-hole grounded 120 Volt A.C. receptacle.

6.Push the primer three (3) times.

7.Push starter button until engine starts.

IMPORTANT: Do not crank engine more than five continu- ous seconds between each time you try to start. Wait 5 to 10 seconds between each attempt.

8.When the engine starts, release the starter button and slowly move the choke control to the “OFF” position.

9.Disconnect the power cord from the receptacle first, then from the engine.

Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operat- ing temperature.

WARM START - ELECTRIC STARTER

Follow the steps above, keeping the choke control in the “OFF” position.

COLD START - RECOIL STARTER

1.Insert safety ignition key (tied to recoil start cord) into ignition slot until it clicks. DO NOT turn the key. Keep the extra safety ignition key in a safe place.

2.Place throttle control in “FAST” position.

3.Rotate choke control to “FULL” position.

4.Push the primer four (4) times if the temperature is below 15°F, or two (2) times if temperature is between 15° and 50°F. If temperature is above 50°F, priming is not necessary.

NOTE: Over priming may cause flooding, preventing the engine from starting. If you do flood the engine, wait a few minutes before attempting to start and DO NOT push the primer.

5.Pull recoil starter handle quickly. Do not allow starter rope to snap back.

6.When the engine starts, release the recoil starter handle and slowly move the choke control to the “OFF” posi- tion.

Allow the engine to warm up for a few minutes. Engine will not develop full power until it has reached normal operat- ing temperature.

WARM START - RECOIL STARTER

Follow the steps above, keeping the choke in the “OFF” position. DO NOT push the primer.

BEFORE STOPPING

Run the engine for a few minutes to help dry off any mois- ture on the engine.

IF RECOIL STARTER HAS FROZEN

If the recoil starter has frozen and will not turn the engine, proceed as follows:

1.Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible.

2.Release the recoil starter handle and let it snap back against the starter.

If the engine still fails to start, repeat the above steps or use the electric starter.

SNOW THROWING TIPS

•Always operate the snow thrower with the engine at full throttle. Full throttle offers the best performance.

•Go slower in deep, freezing or heavy wet snow. Use the drive speed control, NOT the throttle, to adjust speed.

•It is easier and more efficient to remove snow imme- diately after it falls.

•The best time to remove snow is the early morning. At this time the snow is usually dry and has not been ex- posed to the direct sun and warming temperatures.

•Slightly overlap each successive path to ensure all snow will be removed.

•Throw snow downwind whenever possible.

•Adjust the skid plates to proper height for current snow conditions. See “TO ADJUST SKID PLATES” in this section of this manual.

•For extremely heavy snow, reduce the width of snow removal by overlapping previous path and moving slowly.

•Keep engine clean and clear of snow during use. This will help air flow and extend engine life.

•After snow-throwing is completed, allow engine to run for a few minutes to melt snow and ice off the engine.

•Clean the entire snow thrower thoroughly after each use and wipe dry so it is ready for next use.

WARNING: Do not operate snow thrower if weather conditions impair vis- ibility. Throwing snow during a heavy, windy snowstorm can blind you and be hazardous to the safe operation of the snow thrower.

13

Page 12 Page 14
Page 13
Image 13
Husqvarna 1330SB owner manual Snow Throwing Tips, To Start Engine, Before Stopping, If Recoil Starter has Frozen
Page 12 Page 14

1330SB specifications

The Husqvarna 1330SB is a robust and versatile snow blower designed to tackle even the harshest winter conditions with efficiency and ease. Known for its durability and powerful performance, this model has become a popular choice among homeowners and professionals alike.

One of the standout features of the Husqvarna 1330SB is its 291cc engine, which delivers an impressive output for clearing snow. This powerful engine allows the machine to handle heavy snowfall, making it suitable for regions that experience significant winter weather. The electric start mechanism ensures that users can start the snow blower easily, even in frigid temperatures.

The 1330SB features a 30-inch clearing width, which enables it to clear large areas efficiently in a single pass. The high performance auger system is designed to break through ice and compacted snow, ensuring thorough and effective snow removal. The heavy-duty auger and impeller work in tandem to throw snow up to 50 feet away, making it perfect for clearing driveways, sidewalks, and larger areas without the need for multiple passes.

In terms of maneuverability, the Husqvarna 1330SB is equipped with power steering, allowing for easy navigation around obstacles. The adjustable handlebar adds an additional layer of comfort, enabling users to customize the height according to their preference. Furthermore, the track drive system enhances stability and traction, ensuring that the snow blower can handle uneven terrain and heavy snowfall without slipping.

The 1330SB also incorporates advanced features such as a remote chute rotation control, allowing users to easily direct the snow where they want it to go. This is particularly beneficial when clearing large areas or navigating around cars and other obstacles. The adjustable deflector ensures that snow can be thrown at various heights, adding to the versatility of this snow blower.

Lastly, the Husqvarna 1330SB is built with quality materials and superior engineering, ensuring longevity and robust performance year after year. Coupled with its powerful motor and user-friendly features, it stands out as an excellent investment for anyone looking to make winter snow removal a hassle-free experience. Whether you're managing a residential property or tackling a commercial snow clearing task, the Husqvarna 1330SB is equipped to deliver outstanding results.
Top Page Image Contents