![](/images/new-backgrounds/1167619/16761917x1.webp)
OPERATION
GASOLINE
FILLER CAP
MUFFLER
CHOKE CON-
ELECTRIC AUGER
START CONTROL
BUTTON LEVER
RECOIL (AUXILIARY)
STARTER
HANDLE
CHUTE DEFLECTOR
DISCHARGE CHUTE CONTROL LEVER
DRIVE SPEED | DEFLECTOR | TRACTION |
CONTROL LEVER | REMOTE | DRIVE |
| CONTROL | CONTROL |
| LEVER | LEVER |
TROL
PRIMER
SAFETY IGNITION KEY
FUEL
VALVE THROTTLE / ENGINE CONTROL
DISCHARGE
CHUTE
LH TURN TRIGGER
LIGHT
HANDLE
KNOB
NOTE: ITEMS ABOVE
ARE SHOWN IN
THEIR TYPICAL
LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT.
MUFFLER
TOOLBOX
DRIFT
CUTTER
AUGERS | SKID PLATE |
|
Fig. 10
MEETS A.N.S.I. SAFETY REQUIREMENTS
Our snow throwers conform to the standards of the American National Standards Institute.
Toolbox - used to store spare shear bolts, locknuts and wrench.
Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.
Electric start button - used for starting the engine.
Recoil (auxiliary) starter handle - used for starting engine.
Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.
Choke Control - used for starting a cold engine.
Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.
LH and RH turn triggers - used to steer the snow thrower.
Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.
Traction drive control lever - used to engage
Auger control lever - used to engage auger motion (throw snow).
Discharge chute control lever - used to change the di- rection the snow is thrown.
Deflector remote control lever - used to change the di- stance the snow is thrown.
Skid plate - used to adjust height of scraper bar from the ground.
Drift cutter - used to cut through deep snowdrifts.
9