Manuals / Husqvarna / Lawn and Garden / Snow Blower

Husqvarna 96193005700, 1830SB manual Assembly / Pre-Operation, Check Tire Pressure

Models: 96193005700 1830SB

1 24

Page 7

ASSEMBLY / PRE-OPERATION

	1/4-20	SPRING
	1/4-20	CHUTE
	SHOULDER	CHUTE
	SHOULDER	DEFLECTOR
	BOLT	DEFLECTOR
	BOLT
		HOOK
		BETWEEN
		HEX NUTS
		ON CHUTE
	1/4-20	ROTATER
	LOCKNUT	HEAD
		5/16-18
		CARRIAGE
		BOLT
	CABLE
	EYELET
	REMOTE
	CABLE
	BRACKET
	5/16-18
	LOCKNUT

FIG. 8

CHUTE DEFLECTOR

CONTROL LEVER

FIG. 9

CHECK TIRE PRESSURE

The tires on your snow thrower were overinflated at the fac- tory for shipping purposes. Correct and equal tire pressure is important for best snow throwing performance.

•Reduce tire pressure to 14-17 PSI.

Page 7

Image 7

Husqvarna 96193005700, 1830SB manual Assembly / Pre-Operation, Check Tire Pressure

Contents

Operators Manual 1830SBOperation Safe Operation Practices for Walk-Behind Snow ThrowersTraining PreparationPRODUCT SPECIFICATIONS TABLE OF CONTENTSMaintenance and Storage Clearing a Clogged Discharge ChuteREMOVE SNOW THROWER FROM CARTON ASSEMBLY / PRE-OPERATIONHOW TO SET UP YOUR SNOW THROWER PARTS PACKED SEPARATELY IN CARTONUNFOLD UPPER HANDLE ASSEMBLY / PRE-OPERATIONINSTALL SPEED CONTROL ROD See Figs. 1 and INSTALL TRACTION DRIVE CONTROL ROD See Figs. 3 andINSTALL CHUTE DEFLECTOR REMOTE CONTROL See Figs. 8 and ASSEMBLY / PRE-OPERATIONINSTALL AUGER CONTROL ROD See Figs. 5 and INSTALL DISCHARGE CHUTE / CHUTE ROTATER HEAD See FigCHECK TIRE PRESSURE ASSEMBLY / PRE-OPERATIONKNOW YOUR SNOW THROWER OPERATIONOPERATION MEETS A.N.S.I. SAFETY REQUIREMENTSRecoil auxiliary starter handle - used for starting the engine TO USE FUEL SHUT-OFF VALVE See Fig HOW TO USE YOUR SNOW THROWEROPERATION STOPPINGTO THROW SNOW See Fig USING THE CLEAN-OUT TOOL See FigPOWER STEERING OPERATION See Fig OPERATIONTo avoid engine problems, the fuel BEFORE STARTING THE ENGINETO ADJUST SKID PLATES See Fig hol or using ethanol or methanol can attractBEFORE STOPPING SNOW THROWING TIPSOPERATION TO START ENGINELUBRICATION MAINTENANCEGENERAL RECOMMENDATIONS BEFORE EACH USEBELTS CLEANINGENGINE MAINTENANCETO ADJUST SNOW THROWER HEIGHT SERVICE AND ADJUSTMENTS1. Be sure the on/off switch is in the OFF position 2. Remove safety ignition keyTO REPLACE BELTS See Fig SERVICE AND ADJUSTMENTSTO REMOVE WHEELS See Fig SERVICE AND ADJUSTMENTSTO ADJUST CABLE TENSION See Fig ENGINEENGINE STORAGEOTHER SNOW THROWEREngine idles or TROUBLESHOOTINGLoss of power Does not startSERVICE NOTES SERVICE NOTES SERVICE NOTES SECTION 3 ITEMS NOT COVERED BY THIS WARRANTY WARRANTY STATEMENTSECTION 1 LIMITED WARRANTY SECTION 2 HUSQVARNA’S OBLIGATIONS UNDER THE WARRANTY