STARTING AND STOPPING

Check before starting

WARNING! When the engine is started with

!the choke in either the choke or start throttle positions the cutting attachment will start to rotate immediately.

Never start the machine indoors. Exhaust fumes can be dangerous if inhaled.

Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment.

Place the machine on the ground, ensure the cutting attachment is clear of twigs and stones. Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot). Then grip the starter handle with your right hand and pull the starter cord.

For safety reasons follow these recommendations!

Check that the support flange is not cracked due to fatigue or due to being tightened too much. Discard the support flange if it is cracked.

Ensure the locking nut has not lost its captive force. The nut lock should have a locking force of at least 1.5 Nm. The tightening torque of the locking nut should be 35-50 Nm.

Check that the trimmer head and trimmer guard are not damaged or cracked. Replace the trimmer head or trimmer guard if they have been exposed to impact or are cracked.

Never use the machine without a guard nor with a defective guard.

Starting and stopping

WARNING! The complete clutch cover and

!shaft must be fitted before the machine is started, otherwise the clutch can come loose and cause personal injury.

Always move the machine away from the refuelling area before starting. Place the machine on a flat surface. Ensure the cutting attachment cannot come into contact with any object.

Make sure no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 metres.

Starting

Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled.

Choke: Set the choke control in the choke position.

Hold the body of the machine on the ground using your left hand (CAUTION! Not with your foot!). Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Never wrap the starter cord around your hand

English – 13

Page 13
Image 13
Husqvarna 223L manual Starting and Stopping, Check before starting, Starting and stopping