MAINTENANCE

Spark plug

Maintenance schedule

The condition of the spark plug is affected by:

Below follows some general maintenance instructions.

If you need further information please contact your service workshop.

An incorrect carburettor setting.

An incorrect fuel mixture (too much or faulty oil).

A dirty air filter.

These factors cause deposits on the spark plug electrode that may result in malfunction or starting difficulties.

Daily maintenance

1.Clean the outside of the

machine.

2.Make sure the throttle

trigger lock and the

throttle function correctly

from a safety point of

view.

3.Check that the stop

switch functions.

1

2

If the machine is low on power, difficult to start or runs poorly while idling always check the spark plug first.

If the spark plug is dirty, clean it and at the same time check that the electrode gap is 0.5 mm. The spark plug should be changed after about one month of operation or earlier if necessary.

NOTE! Always use the recommended type of spark plug. An incorrect spark plug can damage the cylinder/piston.

Angle gear

The angle gear is filled with a sufficient quantity of grease at the factory. However, before using the machine you should check that the angle gear is filled to 3/4 with grease. Use HUSQVARNA special grease.

Normally, the grease does not need to be changed except when repairs are carried out.

Two-part shaft

The end of the drive axle in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive axle ends (splined coupling) on two- part shafts jam if they are not lubricated regularly.

4.Check that the cutting

head does not rotate while

idling.

5.Clean the air filter.

Replace if necessary.

6.Check that the guard is

undamaged and not

cracked. Replace the

guards if they have been

exposed to impact or are

cracked.

7.Check that the trimmer

head is undamaged and

not cracked. Replace the

trimmer head if necessary.

8.Check that the locking

nut is tight.

9.Check that all nuts and

screws are tightened.

3

4

5

6

7

8

9

English – 19

Page 19
Image 19
Husqvarna 240L, 225LD, 227LD manual Spark plug Maintenance schedule, Angle gear, Two-part shaft, Daily maintenance