ASSEMBLY
CAUTION! Always use the recommended guard for the cutting attachment you are using. See chapter on Technical data.
G
F
D
B 
C
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Place the blade (D) and support flange (F) on the output shaft.
•Fit the nut (G). The nut must be tightened to a torque of
•When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade. You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area
where you should operate the socket spanner when loosening or tightening the nut.
Fitting the trimmer guard and trimmer head Trimmy SII
•Fit the correct trimmer guard (A) for use with the trimmer head. CAUTION! Ensure that the guard extension is fitted.
Hang the trimmer guard/combination guard (A) on the two hooks on the plate holder (M). Bend the guard around the shaft and tighten it with the bolt (L) on the opposite side of the shaft. Use the locking pin (C). Place the locking pin in the groove on the screw head and tighten. See diagram.
H
L
M
B
A
C
AM L
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Screw on the trimmer head (H) in the opposite direction to the direction of rotation.
H
•Tighten the trimmer head to a torque of
•To dismantle, follow the instructions in the reverse order.
English – 15
