GETTING STARTED WITH
HUSQVARNA AUTOMOWER®
1PLACEMENT AND CONNECTING THE CHARGING STATIONSee chapter 3.2 in the Operator’s Manual1. Place the charging station centrally in the work area,leaving a lot of free space in front of the charging station
and on a relatively horizontal surface. | 2 | |
2. Connect the low voltage cable to the charging station and | ||
| ||
transformer. |
| |
3. Connect the transformer’s power cord to a mains wall | 3 | |
socket. The 120V transformer (USA) is for indoor use only. | 2 | |
|
2CHARGING THE BATTERY AND PLACING THE1. Place Automower® in the charging station toSee chapters 3.3 and 3.4 in the Operator’s Manual.BOUNDARY WIRE
charge the battery while you are laying the | 0 cm / 0” | |
boundary wire. Set the main switch to | ||
| ||
the OFF position. |
| |
2. Run the boundary wire ensuring it |
| |
forms a loop around the work area. |
|
10 cm / 4”
35 cm / 14” | 40 cm / 15” |
3 | CONNECTING THE BOUNDARY WIRE |
|
|
| |
| See chapter 3.5 in the Operator’s Manual |
|
| 1. Lift off the cover on the charging station and push in the | 1 |
| ends of the boundary wire in the lower holes of the |
|
charging station and catch them in the upper holes:
• Right wire end in right hole.
•Left cable end in left hole.
2.Open the connector and run the wire ends in the recesses on each connector.
3. Press the connector together using a pair of pliers.
4.Cut off any surplus boundary wire. Cut
5. Press the connector onto the contact pin, marked A, on the charging station. Refit the cover on the charging station.
4
4STARTING AND STOPPING AUTOMOWER®2STARTING1. Open the control panel cover by pressing the STOP button.See chapters 3.7, 4.4 and 4.5 in the Operator’s Manual.
2. Set the main switch to ON position. When you do this for the first time, a start up sequence starts where you select a four digit PIN code among other things. The mower must be in the charging station when you select a PIN code.
3. Close the cover.
STOPPING
Press the STOP button.
23
5
3
1.Charging strip
2.Catch button to open the cutting height adjustment cover
3.STOP button
4. | LED for performance inspection | 2 |
| of boundary wire | |
|
| |
5. | Contact strips | 1 |
6. | Keypad | |
7. | Display |
|
5 4
3 
6 | Main menu | 7 |
Commands
Timer
Garden
Settings
Charging station | Transformer | Low voltage cablel | Boundary wire * | Clinchers * | Connector | Measurement gauge |
|
|
| and coupler |
|
|
|
|
|
|
|
|
| * Not included in package |
