Winter use
|
|
|
|
| The cylinder cover is prepared for extreme cold working conditions. | |||||
Assemble the | remaining | parts in | reverse order |
| In the partition wall | of the cover | there | is a hole, that is covered by a | ||
Lift up the starter cord into the notch on the pulley. Tension the |
| cap (A) when operating at normal temperatures. |
| |||||||
|
|
|
|
|
|
| ||||
return spring | by turning | the pulley | clockwise about two turns. |
| In case of | extreme | cold, this cap | shall | be removed | so that heated |
|
|
|
| air from the cylinder | can flow into the | carburetor | space and | |||
NOTE! |
|
|
| prevent the air filter from being iced up. |
| |||||
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
| |
Make sure that it is possible to turn the pu//ey at least 1/4 of |
|
|
|
|
|
|
| |||
a turn further when the cord is fu//y pu//ed out. |
|
|
|
|
|
|
| |||
|
|
|
|
| NOTE! |
|
|
|
|
|
|
|
|
|
| Under normal temperature conditions the cap has to be | |||||
|
|
|
|
| mounted, Otherwise there is a certain risk of overheating the | |||||
|
|
|
|
| chain | saw. |
|
|
|
|
Adjusting the oil pump capacity
The oil pump is adjustable for four different capacities. Adjustment is to be done after removal of chain, guide bar, clutch cover, centri- fugal clutch and clutch drum.
With a screwdriver the oil capacity can be adjusted by turning the screw. The index on the screw should face the capacity wanted. Figure shows the position for capacity 2.
Recommended positions:
Bar 15“:Pos. 2.
Bar 18 and more: Pos.
Before assembling the clutch drum check that the washer between drum and sealing ring is not lost.
