E N G L I S H
-If it is possible to turn the log, stop cutting 2/3 of the way through the log.
-Turn the log and cut the remaining section from above.
•Cutting a log supported at one end. The log is more than likely to splinter if cut straight through from the top down.
-Make an initial cut from below (approx. 1/3 of the diameter).
-Finish the cut from above.
•Cutting a log supported at both ends. The saw is more than likely to jam in the kerf if cut straight through from above.
-Make an initial cut from the top (approx. 1/3 of the diameter).
-Finish the cut from below.
LIMBING
CAUTION!
Most kickback accidents take place when limbing. Pay very close attention to the kickback danger zone when cutting limbs under tension!
All the principles which apply to crosscutting also apply when cutting thick branches.
Cut complicated branches in several stages.
Ensure that your footing is secure at all times, whether moving about or standing in one place. Always work with the log to your right. For best control, hold the chain saw as close to your body as possible.
12
3
18
