ASSEMBLY
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
•Fit the nut (G). The nut must be tightened to a torque of
Fitting the blade guard and saw blade
K
J
H
I
A
L
•Remove the mounting plate (H). Fit the adapter (I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.
CAUTION! Use the recommended blade guard. See the Technical data section.
G
F
D
B
C
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
•Place the blade (D) and support flange (F) on the output shaft.
•Fit the nut (G). The nut must be tightened to a torque of
•When loosening and tightening the saw blade nut, there is a risk of injury from the teeth of the saw blade.You should therefore always ensure that your hand is shielded by the blade guard when doing this. Always use a socket spanner with a shaft that is long enough to allow this. The arrow in the diagram shows the area where you should operate the socket spanner when loosening or tightening the nut.
Fitting a trimmer guard and Superauto II 1" trimmer head
|
| K |
K | G |
|
F | B | |
| I | |
J | I | C |
|
| |
|
| A |
•Fit the correct trimmer guard (A) for use with the trimmer head. Hook the trimmer guard/combination guard onto the fitting on the shaft and secure with the bolt (L).
•Fit the drive disc (B) on the output shaft.
•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.
•Insert the locking pin (C) in the hole to lock the shaft.
English – 13