Husqvarna 326RX manual Air filter Spark plug, Filing the grass blade, Oiling the air filter

MAINTENANCE

Air filter

Spark plug

The air filter should be cleaned regularly removing dust and dirt to avoid:

•carburetor malfunction

•starting problems

•reduced engine power

•unnecessary wear to engine parts

• abnormal fuel consumption

Clean the filter after every 25 hours or more regularly if operating conditions are

The condition of the spark plug is affected by:

•An incorrect carburetor setting.

•An incorrect fuel mixture (too much or faulty oil).

•A dirty air filter.

These factors cause deposits on the spark plug electrode that may result in malfunction or starting difficulties.

0,5 mm

exceptionally dusty.

Cleaning the air filter Dismantle the air filter cover and remove the air filter. Wash in clean, warm soapy water. Ensure that the

filter is dry before refitting. An air filter used for a long period of time can never be cleaned completely. Therefore it is necessary to replace the filter from time to time with a new filter. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil, see the section on “Oiling the air filter“.

Oiling the air filter

Always use HUSQVARNA filter oil, order no. 503 47 73-01. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact. Put the filter in a plastic bag and the pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter on the machine. Never use com- mon engine oil. This would drain through the filter quite quickly and collect in the bottom.

If the machine is low on power, difficult to start or runs poorly while idling always check the spark plug first.

If the spark plug is dirty, clean it and at the same time check that the electrode gap is 0.5 mm. The spark plug should be changed after about one month of operation or earlier if necessary.

NOTE! Always use the recommended type of spark plug. An incorrect spark plug can damage the cylinder/piston.

Filing the grass blade

!WARNING!

Always stop the engine before starting work on any part of the cutting equipment. This continues to rotate even after the throttle has been released. Ensure that the cutting equipment has stopped completely and remove the cable from the spark plug before you start to work on it.

•See the cutting

equipment’s packaging for correct filing instructions.

• The blades are sharpened using a single cut flat file.

• Sharpen all edges equally to maintain the balance of the blade.

!WARNING!

Always discard a blade that is bent, twisted, cracked, shattered or damaged in any other way. Never attempt to straighten a twisted blade for use again. Only use original blades of the prescribed type.

26 – English