Husqvarna 339XP, 336, Chain Saw manual Assembly 334T, 338XPT

SAFETY EQUIPMENT

Assembly 334T, 338XPT

Assemble the components as follows:

1.Assemble the electrical leads to the lock plate (E) and choke lever/start control (J).

2.Slide in the throttle (H). At the same time, fit the throttle rod

(I) on the throttle. Do not hook on the bearing (F) yet.

3.Using long-nose pliers assemble the lock plate (E). Bolt in position using bolt (D).

4.Slide up the choke lever/start control (J).

J	E
	I

H

D

E

F

5.Fit the pin from the right (C). Now press down the throttle lock (A). Check that the lock’s locking arm enters the cut- out in the throttle and fit the pin (B).

6.Hook on the throttle’s bearing (F). Use a screwdriver to fit the choke rod (G) on the carburettor.

7.Fit the clutch cover and carburettor cover. Adjust the chain tension, see the Operator Guide. Tighten the nuts on the clutch cover to 15 Nm.

8.Check the stop function by starting the chain saw and establishing that it stops when the stop button is moved to the stop position. See the Operator Guide.

B	A
C
D

F

G

20 – English