Husqvarna 359 EPA III, 1151436-95 manual Bar and chain combinations, 050, 058

TECHNICAL DATA

Recommended original and replacement bar and chain combinations

Following is a list of recommended cutting equipment for the Husqvarna chain saw models 357XP and 359. The combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and vibration requirements of ANSI B 175.1–2000.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding maximum nose radius of a hard nose.

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also achieve kickback reduction.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Bar and chain combinations

Chain saw models Husqvarna 357XP and 359 met the kickback performance requirements of ANSI B 175.1-2000 when tested with the combinations of bars and saw chains listed below. The saw chain Husqvarna H30 is also classified as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI B 175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models Husqvarna 357XP and 359. Other chain saw models may not meet the kickback requirements when equipped with the listed bar and chain combinations.

		Bar			Chain
Length, inch	Pitch, inch	Gauge, inch	Max. nose radius	Type		Drive link count
13	0,325	1,5	10T			56
15	0,325	1,5	10T			64
16	0,325	1,5	10T	Husqvarna H25		66
18	0,325	1,5	10T			72
20	0,325	1,5	12T			78
13	0,325	1,3	10T			56
15	0,325	1,3	10T			64
16	0,325	1,3	10T	Husqvarna H30		66
18	0,325	1,3	10T			72
20	0,325	1,3	10T			78
15	3/8"	1,5	11T			56
16	3/8"	1,5	11T			60
18	3/8"	1,5	11T	Husqvarna H42		68
20	3/8"	1,5	11T			72
24	3/8"	1,5	11T			84

Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the corresponding bar, see the table below.

0,050”	H30	H22
0,058”	-	H25

40 – English