MAINTENANCE
6.Wait one minute to allow oil to settle. Use guage on oil fill cap/dipstick for checking level. Insert dipstick into the tube and rest the oil fill cap on the tube. DO NOT thread the cap into the tube when taking reading.
OIL FILL CAP |
/ DIPSTICK |
UPPER |
MARK |
LOWER |
MARK |
FIG. 13
7.Continue adding small amounts of oil and rechecking the dipstick until it reads full. DO NOT overfill, or engine will smoke on startup.
8.Always be sure to retighten oil dipstick before starting engine.
9.Reconnect spark plug wire to spark plug.
AIR FILTER
Your engine will not run properly and may be damaged by using a dirty air filter. Replace the air filter every 100 hours of operation or every season, whichever occurs first. Service air cleaner more often under dusty conditions. See the maintenance section of your engine manual.
MUFFLER
Inspect and replace corroded muffler as it could create a fire hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of each mowing season or after every 100 hours of operation, whichever occurs first. Spark plug type and gap setting are shown in the “PRODUCT SPECIFICATIONS” section of this manual.
CLEANING
IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
•Clean the underside of your lawn mower by scraping to remove
•Clean engine often to keep trash from accumulating. A clogged engine runs hotter and shortens engine life.
•Keepfinishedsurfaces/wheelsfreeofallgasoline,oil,etc.
•We do not recommend using a garden hose to clean lawn mower unless the electrical system, muffler, air filter and carburetor are covered to keep water out. Water in engine can result in shortened engine life.
CLEAN UNDER DRIVE COVER
Clean under drive cover at least twice a season. Scrape un- derside of cover with putty knife or similar tool to remove any
SERVICE AND ADJUSTMENTS
CAUTION: To avoid serious injury, before performing any service or adjustments:
1.Release control bar and stop engine.
2.Make sure the blade and all moving parts
have completely stopped.
3.Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See “TO ADJUST CUTTING HEIGHT” in the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the rear wheels of your mower, is provided to minimize the possibility that objects will be thrown out of the rear of the mower into the operator's mowing position. If the deflector becomes damaged, it should be replaced.
TO REMOVE DRIVE BELT (See Fig. 14)
1. Remove drive cover and belt keeper.
DRIVE
COVER
GEARCASE
PULLEY
BELT
KEEPER
BELT
12 | FIG. 14 |
