Husqvarna 5524SEB owner manual Meets A.N.S.I. Safety Requirements

OPERATION

GASOLINE FILLER CAP

MUFFLER

CHOKE

CON-

TROL

PRIMER

SAFETY IGNITION KEY

ELECTRIC AUGER

START CONTROL

BUTTON LEVER

RECOIL (AUXILIARY)

STARTER

HANDLE

CHUTE DEFLECTOR

DISCHARGE CHUTE

DISCHARGE CHUTE CONTROL LEVER

DRIVE SPEED

CONTROL LEVER

TRACTION

DRIVE

CONTROL

LEVER

FUEL SHUT-OFF VALVE

THROTTLE / ENGINE CONTROL

CLEAN-OUT TOOL

HANDLE KNOB

MUFFLER

NOTE: ITEMS ABOVE

ARE SHOWN IN

THEIR TYPICAL

LOCATION ON THE ENGINE. ACTUAL LOCATION MAY VARY WITH THE ENGINE ON YOUR UNIT.

AUGERS

FIG. 8

TOOLBOX

SKID PLATE

MEETS A.N.S.I. SAFETY REQUIREMENTS

Our snow throwers conform to the standards of the American National Standards Institute.

Toolbox - used to store spare shear bolts, locknuts and wrench.

Safety ignition key - must be inserted for the engine to start and run. Remove when snow thrower is not in use.

Electric start button – used for starting the engine.

Recoil (auxiliary) starter handle – used for starting the engine.

Primer - pumps additional fuel from the carburetor to the cylinder for use when starting a cold engine.

Throttle/engine control - used to select either FAST or SLOW engine speed and to STOP the engine.

Choke control - used for starting a cold engine.

Drive speed control lever - used to select forward or reverse motion and speed of snow thrower.

Traction drive control lever - used to engage power-pro- pelled forward or reverse motion of snow thrower.

Auger control lever - used to engage auger motion (throw snow).

Discharge chute control lever - used to change the di- rection the snow is thrown.

Skid plate - used to adjust height of scraper bar from the

8ground.