EFFECTIVE JANUARY 1, 2009

Refer to Section 3 for items not covered by this warranty

workmanship or a period of two years or 2000 hours of operation, whichever first occurs, from the date of purchase.) & 1 Year or 1,000 Hour Body Warranty (All remaining components of the vehicle not specified otherwise and all other original equipment options and accessories supplied by Husqvarna are warranted with respect to parts and labor against defects in material and workmanship for a period of one year or 1000 hours of operation, whichever first

*All consumer product use must have been limited to the owner s residence. Warranted for noncommercial, nonprofessional, noninstitutional and nonincome producing use.

RETAILER

**HUV 2 Year or 2,000 Hour Powertrain (The engine assembly, unitized transaxle assembly (gasoline vehicle), motor, and main frame assembly are warranted with respect to parts and labor against defects in material and

 

occurs, from the date of purchase.)

HUV s Gas & Diesel Powered Battery: 0 – 6 months free replacement and 7 – 12 months prorated

HUV s Electric Powered – 4 year or 16,000 Energy Unit Limited Warranty Period

***Husqvarna safety apparel warranty is from the date of the customer s original purchase for defects in material and workmanship. Normal wear, tear or abuse is not covered under warranty. All care and maintenance instructions must be followed as stated by the manufacturer on the care label. The fit of the protective apparel/boot is not covered under warranty.

SECTION 4: EXCEPTIONS AND LIMITATIONS

****Battery 1 Year prorated limited warranty with 100% replacement during the first 6 months.

WARRANTY

¥ Effective manufacturing date 2/1/09. Units with serial number started 0905XXXXX or greater are affected.

 

 

Lifetime Warranty (Parts and Labor): All tiller tines and trimmer shafts against breakage. Proof of purchase required.

POLICY

Lifetime Warranty (“PARTS ONLY” after initial warranty expiration): Ignition coils and modules on handheld product. Proof of purchase required.

SECTION 2: HUSQVARNA S OBLIGATIONS UNDER THE WARRANTY

Husqvarna will repair or replace defective components without charge for parts or labor if a component fails because of a defect in material or workmanship during the warranty period.

&

SECTION 3: ITEMS NOT COVERED BY THIS WARRANTY

 

The following items are not covered by this warranty:

 

(1)

Normal customer maintenance items which become worn through normal regular use, including, but not limited to, belts, blades, blade adapters, bulbs, clutches, clutch drums, filters (fuel line, fuel filters, air filters, oil filters),

 

 

sprockets, guide bars, lubricants, rewind springs, saw chain, spark plugs, starter ropes and tiller tines;

 

(2)

Natural discoloration of material due to ultraviolet light;

 

(3)

Engine and drive systems not manufactured by Husqvarna; these items are covered by the respective manufacturer s warranty as provided in writing with the product information supplied at the time of purchase; all claims must be

 

sent to the appropriate manufacturer.

PROCEDURE

 

 

(4)

Lawn and garden attachments that are covered by a third party which gives a warranty, all claims for warranty should be sent to the manufacturer.

MANUAL

(5)

Commercial or consumer mowing decks with sand abrasion damage.

(6)

Emission Control System components necessary to comply with CARB-TIER II and EPA regulations which are manufactured by third party engine manufacturer.

 

 

This warranty shall be inapplicable to defects resulting from the following:

(1)Accident, abuse, misuse, negligence and neglect, including stale fuel, dirt, abrasives, moisture, rust, corrosion, or any adverse reaction due to incorrect storage or use habits;

(2)Failure to operate or maintain the unit in accordance with the Owner s/Operator s manual or instruction sheet furnished by Husqvarna;

(3)Alterations or modifications that change the intended use of the product or affects the product s performance, operation, safety, or durability, or causes the product to fail to comply with any applicable laws; or:

(4)Additional damage to parts or components due to continued use occurring after any of the above.

REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HUSQVARNA SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THESE PRODUCTS EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THESE PRODUCTS IS LIMITED IN DURATION TO THE WARRANTY PERIOD AS DEFINED IN THE LIMITED WARRANTY STATEMENT. HUSQVARNA RESERVES THE RIGHT TO CHANGE OR IMPROVE THE DESIGN OF THE PRODUCT WITHOUT NOTICE, AND DOES NOT ASSUME OBLIGATION TO UPDATE PREVIOUSLY MANUFACTURED PRODUCTS.

Some states do not allow the exclusion of incidental or consequential damages, or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary by state.

SECTION 5: CUSTOMER RESPONSIBILITIES

The product must exhibit reasonable care, maintenance, operation, storage and general upkeep as written in the maintenance section of the Owner s/Operator s manual. Should an operational problem or failure occur, the product should not be used. Failure caused by continued use is not covered by warranty. Product should be delivered, at owners expense, as is, to an authorized Husqvarna Servicing Retailer for evaluation. Proof of purchase, as explained in section 6, rests solely with the customer.

SECTION 6: PROCEDURE TO OBTAIN WARRANTY CONSIDERATION

It is the Owner s and Retailer s responsibility to make certain that the Warranty Registration Card is properly filled out and mailed to Husqvarna. This card should be mailed within ten (10) days from the date of purchase in order to confirm the warranty and to facilitate post-sale service. Proof of purchase must be presented to the authorized Husqvarna retailer in order to obtain warranty service. This proof must include date purchased, model number, serial number, and complete name and address of the selling retailer. To obtain the benefit of this warranty, the product believed to be defective must be delivered to an authorized Husqvarna retailer in a timely manner, no later than thirty

(30)days from date of the operational problem or failure. The product must be delivered at the owner s expense. Downtime, pick-up and delivery charges are not covered by this warranty. An authorized Husqvarna retailer can be located by calling 1-800-HUSKY-62 or visiting www.husqvarna.com

Subject to change without notice.

HUSQVARNA 7349 Statesville Road, Charlotte, NC 28269

Part # 531 30 96-85

Page 19
Image 19
Husqvarna 7021P owner manual Policy

7021P specifications

The Husqvarna 7021P is a powerful and efficient gas-powered lawn mower that stands out for its robust performance and user-friendly features. Designed for residential use, this mower combines power, precision, and convenience to help homeowners achieve the perfect lawn.

At the heart of the Husqvarna 7021P is a reliable 160cc gas engine, which delivers ample power for cutting through thick grass and tackling uneven terrain. This engine is designed to start easily and provide consistent performance, ensuring that the mower operates smoothly during each mowing session. The 7021P features a 21-inch cutting deck, making it ideal for medium-sized yards, allowing users to cover more ground with fewer passes.

One of the standout features of the Husqvarna 7021P is its 3-in-1 cutting system. This versatile system gives users the option to mulch, rear bag, or side discharge the clippings, offering flexibility based on personal preference and lawn care needs. Mulching is particularly beneficial as it recycles the grass clippings back into the soil, promoting healthy grass growth and reducing waste.

The mower is equipped with a dual-lever height adjustment system, allowing users to easily set the cutting height to their desired level. This feature provides a range of cutting heights, accommodating different grass types and conditions.

Additionally, the Husqvarna 7021P features durable wheels that provide excellent traction and maneuverability. The front wheels are 8 inches, while the rear wheels are 11 inches, allowing for smooth navigation over various terrains. The mower also includes an ergonomically designed handle, which not only enhances user comfort but also folds down for easy storage.

A thoughtful design characteristic of the 7021P is its easy-access fuel tank, which simplifies refueling during use. Moreover, the mower's lightweight construction makes it easy to maneuver and transport, ensuring that mowing is not only efficient but also an enjoyable experience.

In summary, the Husqvarna 7021P is a well-rounded lawn mower that showcases a blend of power, versatility, and convenience. Equipped with a reliable engine, a 3-in-1 cutting system, height adjustment capabilities, and ergonomic features, it is designed to meet the needs of homeowners who seek a reliable tool for maintaining a beautiful lawn. Whether tackling small patches or larger areas, the Husqvarna 7021P is built to deliver excellent results.