OPERATION
The operation of any lawn mower can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your lawn mower or per- forming any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask over spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory for optimum per- formance. Speed is not adjustable.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the risk of blade contact injury. Do not under any circumstances attempt to defeat the function of the operator control. The blade turns when the engine is running.
•Your lawn mower is equipped with an operator presence control bar which requires the operator to be positioned behind the lawn mower handle to start and operate the lawn mower.
DRIVE CONTROL (See Fig. 4)
• |
presence control bar down to the handle and pulling |
the drive control lever rearward to the handle. The |
farther toward the handle the lever is pulled, the faster |
the unit will travel. |
• Forward motion will stop when either the operator pres- |
ence control bar or drive control lever are released. To |
stop forward motion without stopping engine, release |
the drive control lever only. Hold operator presence |
DRIVE CONTROL ADJUSTMENT
Over time, the drive control system may become “loose”, resulting in decreased speed. There is a turnbuckle on the underside of the drive control housing to increase tension on the drive cable. Proceed as follows:
1.Turn unit off and disconnect spark plug wire from spark plug.
2.Turn nut on underside of drive control to increase drive speed.
3.Operate mower to test drive speed. Readjust as re- quired.
4.If condition fails to improve after the above steps (for- ward speed remains the same), your drive belt is worn and should be replaced.
TO ADJUST CUTTING HEIGHT (See Fig. 5)
Raise wheels for low cut and lower wheels for high cut, adjust cutting height to suit your requirements. Medium position is best for most lawns.
•To change cutting height, squeeze adjuster lever toward wheel. Move wheel up or down to suit your requirements. Be sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when plate tab inserts into hole in lever. Also,
LEVER BACKWARD TO LOWER MOWER
control bar down against handle to continue mowing |
without |
NOTE: If after releasing the drive control the mower will not roll backwards, push the mower forward slightly to disengage drive wheels.
OPERATOR PRESENCE CONTROL BAR | ||
|
| DRIVE |
|
| CONTROL |
| TO | LEVER |
ADJUSTMENT | ENGAGE | DRIVE |
TURNBUCKLE | DRIVE | CONTROL |
(ON UNDERSIDE) | CONTROL | DISENGAGED |
FIG. 4
PLATE
TAB
LEVER FORWARD TO RAISE MOWER
FIG. 5
LEVER
6
