Husqvarna owner manual Set up, INSTALLING HANDLE BCZ3200DL, INSTALLING HANDLE BCZ3200DW, Blade

BCZ3200DL / BCZ3200DW

6. Set up

INSTALLING HANDLE (BCZ3200DL)

•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you.

INSTALLING HANDLE (BCZ3200DW)

1.Loosen the 4bolts on the upper cap and insert the handles equally. Retighten the bolts.

2.Put the handle assembly into the bracket and put the upper cap over it. Tighten the cap securely.

CONNECTING THROTTLE WIRE (BCZ3200DL/DW)

1.Remove the air cleaner cover.

2.Connect the end of the throttle wire to the joint on the top of the carburetor.

CONNECTING SWITCH WIRES (BCZ3200DL/DW)

•Connect the switch wires between the engine and the main unit.

PROTECTOR (BCZ3200DW)

•Wrap the protector around the outer pipe as shown in the figure, and fasten the hooks.

INSTALLING DEBRIS GUARD FOR LINE HEAD

•Attach the debris guard with the bolts provided while inserting the spacer between the guard and the pipe.

INSTALLING LINE HEAD

1.While locking the gear shaft by inserting the angled bar(1) into the holder(A)(2) on the gear box, loosen and remove the nut (left-handed).

2.Fit the line head assembly to the gear shaft. Tighten it securely by hand.

INSTALLING DEBRIS GUARD FOR METAL BLADE

•When using metal blade, make sure to remove the guard skirt.

BLADE

1.Put the angled bar(1) into the side holes of the holder(A)(2) and the gear case.

2.Remove the nut (left-handed) and the holder(B)(3) from the gear shaft.

3.Put the blade onto the holder(A)(2). Make the marked side face the holder.

4.Put the holder(B)(3) onto the gear shaft making the recessed side face the blade.

5.Fasten the blade by the nut and the cover(4).

BALANCE UNIT

1.Put on strap and attach unit to strap.

2.Slide clamp up or down until unit balances with head aparting from the ground when using it.

GB-8