ASSEMBLY
Fitting the bevel gear
Fit the bevel gear on the shaft. Turn the cutter so that the shaft engages in the bevel gear.
Position the bevel gear so that the slot aligns with the line on the shaft.
Firmly tighten the screw.
Fitting the cutter
Fit the cutter as follows:
1Fit the drive disc (A) on the output shaft. Make sure that the edge that engages in the hole in the cutter is facing outwards.
2Prevent the cutter from rotating by inserting the locking pin in the hole behind the cutter guard, so that it engages it in the corresponding hole in the drive disc.
3Place the cutter (B) on the drive disc.
4Fit the support flange (C). The support flange must be fitted so that its outer edge presses against the cutter.
5Fit the locking nut (D). CAUTION! The locking nut has a
6Remove the locking pin.
CAUTION! Do not forget to remove the locking pin before using the machine.
WARNING! Under no circumstances may the
!edger cutter be used without the cutter guard fitted.
English – 7
