15
PARTS IDENTIFICATION (WHAT IS WHAT)
AA. Emergency Stop Switch: Depress Switch to STOP
engine in emergencies. Reset by pulling outward (pull up)
to allow re-starting of machine.
BB. Tool Compartment: Contains Operation Manual,
Parts List, & two wrenches (T & U) (13mm & 27mm).
Open by turning knob 180 degrees. Always return Opera-
tion Manual to this area for future reference.
CC. Engine Throttle: Controls Engine speed (RPM).
Push forward to increase engine speed. Pull backwards
to decrease engine speed. All sawing is done at maxi-
mum engine speed.
DD. Engine Start Switch: Located on engine, behind
Front Cover (V). Must be ON (1) to start engine. Use to
turn engine OFF (“0”) in non-emergency situations.
EE. Blade Depth Control: Turn Counter-Clockwise to
raise Diamond Blade (H) and Clockwise to lower Diamond
Blade (H).
FF. Blade Depth Stop: To Lock Blade Depth Control (EE)
in position. Pull Blade Depth Stop toward rear of machine
and turn 90 degrees to lock in open position.
GG. Blade Depth Indicator: Shows cutting depth of Dia-
mond Blade (H) in centimeters (orange color) and inches
(white color). Operation: With engine OFF (“0”), lower
Diamond Blade (H) until in contacts the cutting surface.
Rotate Blade Depth Indicator to align “0” with arrows.
Raise Saw. When saw is lowered into cut, current cutting
depth is shown.
HH. Engine Tachometer (RPM): Shows engine speed in
revolutions per minute if engine is running. Shows total
operation time when engine is OFF (“0”). Total operation
time shown in minutes from 0-59 minutes, and hours for
60+ minutes.
II. – – –
JJ. Rear Handle: Operator position is behind machine
with both hands on Rear Handle. Handle is adjustable to
several positions.
KK1. Water Control Valve: Controls water ow to blade.
Located on Left side of machine, near Rear Handle (RR).
Not used with the water tank (if equipped).
KK2. Blade Guard Water Control Valve: Controls the
water ow to the blade. Located on blade guard. Used
with water tank (if equipped).
LL. Belt Guard (Not Shown): Covers engine drive belt.
MM. Belt Drive Idler: Used to hold tension on Blade
Shaft Drive Belt.
NN. Oil Drain Hose: Use to remove oil from engine.
OO. Parking Brake (EU units only): Use to hold ma-
chine in parked position. Located at Right Rear Wheel,
at rear of machine. Operation: To engage, rotate lever
upward, so rod is allowed to move inward. To dis-engage,
pull rod inward and rotate downward so rod is xed in the
inward position.