Husqvarna FT900 To Adjust Carburetor, Check Tine Operation, Replace Belt Guard, Engine, Fig

SERVICE AND ADJUSTMENTS

CHECK TINE OPERATION

•See “TINE OPERATION CHECK” in this section of manual.

REPLACE BELT GUARD

FORWARD MOTION (INSIDE) V-BELT
ENGINE PULLEY	TRANSMISSION PULLEY
BELT GUIDE
REVERSE
IDLER PULLEY
BELT GUIDE
FORWARD IDLER PULLEY
REVERSE (OUTSIDE) V-BELT
REVERSE
IDLER
PULLEY
ENGINE PULLEY
FORWARD
IDLER PULLEY	belts	10
FRONT VIEW REFERENCE
REVERSE		IDLER
IDLER PULLEY
		ARM PIN
	ENGINE
	PULLEY

ENGINE

Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the custom- ers expense, may be performed by any non-road engine repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer's service outlet.

TO ADJUST CARBURETOR

The carburetor has been preset at the factory and adjustment should not be necessary. However, engine performance can be affected by differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, contact your nearest authorized service center/department

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/ DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.

	Fig. 21
REVERSE	REVERSE IDLER ARM	REVERSE (OUTSIDE) V-BELT
IDLER PULLEY
IDLER		BELT
ARM PIN		GUARD
		BOLT
FORWARD MOTION
(INSIDE) V-BELT
ENGINE PULLEY		TRANSMISSION
		PULLEY
BELT GUIDE	FORWARD IDLER PULLEY

Fig. 22

15