MAINTENANCE
SLOT |
TAB |
CARTRIDGE |
FILTER COVER |
FIG. 18
MUFFLER
Inspect and replace corroded muffl er as it could create a fi re hazard and/or damage.
SPARK PLUG
Replace spark plug at the beginning of each mowing season or after every 100 hours of operation, whichever occurs
first. Spark plug type and gap setting are shown in the “PRODUCT SPECIFICATIONS” section of this manual.
CLEANING
IMPORTANT: FOR BEST PERFORMANCE, KEEP MOWER HOUSING FREE OF
CAUTION: Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
•Clean the underside of your lawn mower by scraping to remove
•Clean engine often to keep trash from accumulating. A clogged engine runs hotter and shortens engine life.
•Keep finished surfaces / wheels free of gasoline, oil, etc.
•We do not recommend using a garden hose to clean lawn mower unless the electrical system, muffl er, air fi lter and carburetor are covered to keep water out. Water in engine can result in shortened engine life.
WATER WASHOUT FEATURE (See Fig. 19)
Your lawn mower is equipped with a fi tting that allows quick and easy cleaning of the underside of the housing. To use this feature, proceed as follows:
1.Move lawn mower to an area of cut grass or another hard surface.
NOTE: Water, grass and other debris will drain from beneath the mower housing during the washout process.
2.Remove grass catcher and discharge chute assembly from lawn mower.
3.Close mulcher door (if equipped).
4.Connect a garden hose to the fi tting where shown.
IMPORTANT: BE SURE THE GARDEN HOSE IS NOT ROUTED UNDER THE LAWN MOWER HOUSING OR ENTANGLED IN THE WHEELS.
5.Turn on water supply and check for leaks at the fi t- ting.
If no leaks are present, start engine (as described in the Operation section of this manual) and let engine run until the underside of the lawn mower is clean.
WARNING: Do not engage the drive system during the washout process.
6.Shut off the engine.
7.Shut off water supply and remove hose from fi tting.
CAUTION: Do not remove hose from fitting while engine is running. Water in engine can result in shortened en- gine life.
8.Start engine (as described in the Operation section of this manual) and let engine run for a full minute to remove excess water from mower.
HOSE |
FITTING |
FIG. 19
14
