UNASSEMBLED PARTS
| Steering |
| Hoodscoop | |
| Steering |
|
|
|
| Extension |
| Hex Bolt |
|
| Shaft |
|
| |
|
|
|
| |
|
| Insert |
|
|
| Lock Washer |
|
|
|
|
| Steering | Steering | (1) Hood Scoop |
|
|
| ||
Steering Wheel | Washer | Wheel Adapter | Boot |
|
| Seat |
|
| Slope Sheet |
|
| Washer |
|
|
|
|
|
| Key(s) |
Seat |
| Hex Bolt |
|
|
|
| ASSEMBLY |
| |
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | 5/16" wrench | Utility knife |
(2) | 7/16" wrenches | Tire pressure gauge |
(2) 1/2" wrenches | Pliers | |
(1) | 9/16" wrench |
|
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton .
•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.
•Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
TO CHECK BATTERY (See Fig. 1)
•Lift seat to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at
•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.
LABEL
Fig. 1
5
