Husqvarna PN 249512 instruction manual D. Fuel Mixture, English

Models: PN 249512

1 10
Download 10 pages 3.48 Kb
Page 6
Image 6
D. Fuel Mixture

Before starting to cut again make sure your position is correct.

To reduce the fire hazard keep the engine and muffler free of twigs, leaves or excess lubricant.

Watch out for the sharp edges and hot part of the machine.

Prolonged use of the machine or other equip- ment expose the operator to vibrations that can cause the White Finger Syndrome (Syndrome of

Raynaud). This could reduce the sensitivity of the hands in distinguishing different tempera- tures and cause a general numbness. The operator should therefore check the conditions of the hands and fingers if the machine is used continuously or regularly. If one of the symp- toms should appear, consult a doctor immedi- ately.

D. Fuel Mixture

CAUTION!

Do not smoke while refueling!

Open the cap on the tank by loosening it slowly.

Fill the tank in the open, far from flames or sparks.

Never add fuel in the tank when the engine is running or hot, (let the engine cool off before filling the tank) to avoid the risk of fire.

Avoid contact of the oil and fuel with the skin and eyes.

Fill the tank in a well-ventilated place.

Do not inhale the fumes of the fuel mixture. It is toxic.

Store the fuel mixture in suitable fuel con- tainers only.

PREPARATION OF THE MIXTURE

CAUTION!

Do not use any other type of fuel than the type recommended in this manual.

This machine is equipped with a two-stroke engine and should therefore be fueled with a mixture of unleaded gasoline (with a mini- mum octane rating = 90) and fully synthetic oil specific for two-speed engines that use unleaded gasoline in the proportions indi- cated in the table on the cover, fig. (D)

CAUTION! Control the specifications of the oil shown on the package; the use of

oil lacking the specifications expressly indicat- ed in this manual could cause serious damage to the engine!

To obtain the best mixture, pour the oil into an approved container first, followed by the gaso- line, and shake the container well (every time you take fuel out of it).

Be careful not to spill the gasoline.

The characteristics of the mixture tend to deteri- orate in time, so you should only prepare as much mixture as you are going to need.

FILLING THE TANK

CAUTION! The following precautions should be taken to reduce the fire hazard:

Always ensure there is adequate ventilation.

Do not smoke or take sources of heat or sparks near the fuel.

Refuel with the engine off.

Open the cap on the tank carefully to elimi- nate any excess pressure.

Do not take the cap off the tank with the engine running.

After fueling, close the cap tightly.

Fill the tank in a well-ventilated place.

Place the machine on a solid flat surface so that it cannot tip over, with the cap on the tank fac- ing upward.

Clean the area around the fuel cap before removing it, to prevent any impurities from con- taminating the fuel.

Take the cap off the fuel container carefully. Unscrew the cap on the fuel tank and fill it with the necessary quality, using a funnel.

Take care not to spill any fuel.

After filling the tank, screw the cap on tightly.

CAUTION! If you spill any fuel, wipe it off Manual background the machine. If you have spilt it on your- self, change your clothes at once. Avoid con-

tact with the skin or eyes.

CAUTION! The muffler gets very hot dur- ing use and remains hot for some time

after switching off the engine. This also applies at idle speed. Take every precaution to reduce the fire hazard, especially in the pres- ence of inflammable materials or gas.

ENGLISH - 4

Page 6
Image 6
Husqvarna PN 249512 instruction manual D. Fuel Mixture, English