ASSEMBLY
•Inspection for corrosion.
•Testing battery.
•Jumping (if required).
•Periodic charging.
SEAT
DISCARD
TERMINAL PROTECTIVE CAPS
TERMINAL
ACCESS
DOOR
02180
KEPS | HEX BOLT |
NUT |
|
POSITIVE (RED)CABLE
NEGATIVE (BLACK)CABLE
SEAT PAN
SHOULDER
BOLT
02466
FLAT WASHER
ADJUSTMENT | 02464 |
KNOB |
|
FIG. 2
INSTALL SEAT (See Fig. 3)
Adjust seat before tightening adjustment knob.
•Remove adjustment knob and fl at washer securing seat to cardboard packing and set aside for assembly of seat to tractor.
•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.
•Place seat on seat pan so head of shoulder bolt is positioned over large slotted hole in pan.
•Push down on seat to engage shoulder bolt in slot and pull seat towards rear of tractor.
•Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.
•Lower seat into operating position and sit on seat.
•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
•Get off seat without moving its adjusted position.
•Raise seat and tighten adjustment knob securely.
FIG. 3
NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)
•Press lift lever plunger and raise attachment lift lever to its highest position.
•Release parking brake by depressing brake pedal.
•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).
•Roll tractor forward off skid.
•Remove banding holding the deflector shield up against
tractor.
7
