UNASSEMBLED PARTS
Keys | Slope Sheet |
|
(1) Oil Drain Tube
For Future Use
(2) Keys
ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | 1/2" wrench | Tire pressure gauge |
|
(2) | 7/16" wrenches | Utility knife | Pliers |
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TOREMOVETRACTORFROMCARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton .
•Cut along dotted lines on all four panels of carton. Remove end panels and lay side panels flat.
•Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
TO CHECK BATTERY (See Fig. 1)
•Lift seat to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label is located between terminals) charge battery for minimum of one hour at
•For battery and battery cable installation see "RE- PLACING BATTERY" in the "Service and Adjustments" section in this manual.
LABEL
Fig. 1
5
ADJUST SEAT (See Fig. 2)
•Sit in seat.
•Lift up adjustment lever (A) and slide seat until a com- fortable position is reached which allows you to press clutch/brake pedal all the way down.
•Release lever to lock seat in position.
A |
Fig. 2
NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.
WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a
TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)
•Raise attachment lift lever to its highest position.
•Releaseparkingbrakebydepressingclutch/brakepedal.
•Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).
•Roll tractor forward off skid.
•Remove banding holding the deflector shield up against tractor.
Continue with the instructions that follow.
