OPERATION

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHENOPERATINGINTEMPERATURESBELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission en- gaged position.

•Sit on seat in operating position, depress brake pedal and set parking brake.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to fast position

•Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

•When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can be used during the engine warm-up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32° F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is

running.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. Dis- engage parking brake

•Depress forward drive pedal to full forward position, hold for five (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for five

(5) seconds and release pedal. Repeat this procedure three (3) times.

NOTE: During this procedure there will be no movement of drive wheels. The air is being removed from hydraulic drive system.

12

Page 11 Page 13
Page 12
Image 12
Husqvarna YTH2042TD manual ADD Gasoline, To Start Engine See Fig, Purge Transmission, Automatic Transmission Warm UP
Page 11 Page 13

YTH2042TD specifications

The Husqvarna YTH2042TD is a robust and versatile garden tractor designed to make mowing large areas efficient and enjoyable. This model combines power, performance, and comfort, making it an excellent choice for homeowners with extensive lawns.

One of the standout features of the YTH2042TD is its powerful 20 HP Kohler engine. This reliable engine delivers consistent performance, allowing the mower to tackle tough grass and uneven terrain with ease. The hydrostatic transmission provides a smooth and effortless driving experience, enabling users to adjust speed seamlessly without the need for gear shifting.

The cutting deck of the YTH2042TD measures 42 inches, optimized for efficient mowing. With the ability to adjust the cutting height between 1 to 4 inches, users can choose the ideal trim for their lawn, promoting healthy grass growth. The mower also utilizes a clear-cutting system that ensures an even and precise cut every time.

Incorporating innovative technologies, the Husqvarna YTH2042TD features an easy-to-use deck lift system. This allows users to change the cutting height quickly and effortlessly from the operator’s seat. Additionally, an integrated cruise control feature lets users maintain a steady speed for a more comfortable mowing experience over large areas.

Another key characteristic of the YTH2042TD is its ergonomic design. The high-back seat provides excellent support, allowing users to remain comfortable during longer mowing sessions. The instrument panel is also conveniently located for easy access to controls, enhancing the overall usability of the tractor.

The Husqvarna YTH2042TD stands out for its durability and long-lasting construction. Built with high-quality materials, this mower is engineered to withstand the rigors of regular use, ensuring that it remains operational for years to come. Its robust frame and sturdy build give users confidence that it can handle demanding tasks.

Safety features have also been thoughtfully integrated into the design. The automatic blade engagement system is a standout, ensuring that the mower blades engage smoothly while minimizing the risk of accidents. An ignition switch with a safety interlock prevents the engine from starting unless the mower is in gear.

In conclusion, the Husqvarna YTH2042TD is a feature-rich garden tractor that combines power, comfort, and advanced technology. With its powerful engine, adjustable cutting deck, and ergonomic design, it provides an exceptional mowing experience, making it an ideal choice for those looking to maintain their lawns with ease and efficiency.
Top Page Image Contents