Rev.0303

Installation (continued)

(apply additional silicone if necessary). Remove tape applied on line #4.

11. Remove front, back and end shipping braces.

It is the contractor's responsibility to install case(s) according to local construction and health codes.

6.Slide second case up to first case snugly.Then level second case to the first case so glass front,bumper and top are flush.

Do not use bolts to pull cases together!

7.To compress butyl at joint, use two Jurgenson wood clamps. Make sure case is level from front to back and side to side on inside bulkheads at joint.

8.Attach sections together via the bolts pictured in the illustration below.

1/4” Binding Post

5/16” Bolts

ASCS

Bolt Locations

9.Apply bead of butyl to top of bulkheads and slip on stainless steel bulkhead cap. Also apply silicone to seam between overhead light tubes.

10.Use finger to smooth silicone as thin as possible at masking tape on inside and outside of rear mullion

INSIDE REFRIGERATED WEDGES

Line up taper pins with holes on adjoining case. Turn camlock to lock in.Two camlocks are located at the rear of the case behind the air discharge and behind the lower electrical raceway access panel. Bolt the wedge into the adjoining case in the front. If the adjoining case is refrigerated,the bolt is located under the pans in the front. When the adjoining case is a hot case, the cases are bolted together by mans of a bracket located behind the front panel. Remove the front panel by lifting it up and out..

COMMON END BETWEEN UNLIKE CASES AND HOT CASES

Bolt the end onto the case using the bolts provided in predrilled holes behind the front of the panel through the bracket provided and in the rear behind the rear access panel on the bottom Common ends between refrigerated cases are also bolted together behind the air discharge panel. Remove the discharge panel by lifting up and out.

Hot cases are only bolted in two places, in the rear of the case, behind the access panel, and in the front of the case behind the front panel.

OUTSIDE REFRIGERATED WEDGE:

Taper pin and camlock locations are the same as a standard case.

INSIDE DRY WEDGES

Bolt the wedge into the sides of the adjoining case. Use the bolts provided

INSIDE PEDESTAL WEDGES

Set the wedge on adjoining case’s mounting brackets located at the base of the unit,and bolt down.Drive screws provided through the sides of the wedge (4 screws per side), accessible through the back of the wedge.

1.Secure the joint backer located behind the cart bumper support at the joints.To adjust the front panel. Loosen the screws holding the bumper on the case on either side the joint, and slide the extrusion to the center of the joint.

2.Starting from a center case in a lineup or wedge, align the front panels. Front panels can be loosened and adjusted laterally by loosing the screws holding the case bumper channel.

5