To do this it will be necessary to raise and block the deck, using jack stands or blocks, in the full up position and scrape the
Some repairs require the assistance of a trained service mechanic and should not be attempted by unskilled personnel. Consult your Hustler service center when assistance is needed.
Torque values
WARNING: Particular attention must be given to tightening the drive wheel lug nuts and blade spindle bolts. Failure to correctly torque these items may result in the loss of a wheel or blade, which can cause serious damage or personal injury.
Torque values are given below: |
| Nm |
| ||
Wheel (lug) nuts | ||
Blade spindle bolt top | 118 | 160.01 |
Blade spindle bolt bottom | 118 | 160.01 |
Lug nuts only - It is recommended that these be checked after the first 2 hours of operation, initially, every 50 hours and following removal for repair or replacement.
For all other torques refer to the various tractor parts manuals for standard torque chart. See the Product Literature section of this manaul for ordering information.
For engine torque values, see engine owner’s manual.
Tires
It is important for level mowing that the tires have the same amount of air pressure. The recommended pressure are:
Drive wheels | |
Gauge wheels |
Solid fill tires are not recommended for Hustler turf equipment. On any machine, with solid filled tires, the warranty claim will be denied.
Lubrication
Use SAE
Electrical system
The electrical system is a
battery is recommended. Otherwise, follow battery manufacturer’s maintenance, safety, storing and charging specifications.
WARNING: Battery posts, terminals, and related accessories contain lead and lead compounds, chemi- cals known to the State of California to cause cancer and reproductive harm. Wash hands after handling.
WARNING: Change batteries in an open well venti- lated area, away from spark and flames. Unplug char- ger before connecting or disconnecting from the battery. Wear protective clothing and use insulated tools.
WARNING: Avoid skin and clothing contact with battery acid.
Always wear eye protection when checking the bat- tery, acid can cause serious injury to skin and eyes. If contact occurs, flush area with clean water and call physician immediately. Acid will also damage cloth- ing.
Do not drink the battery electrolyte.
Do not allow open flame near the battery when charg- ing.
Hydrogen gas forms inside the battery. This gas is both toxic and flammable and may cause an explosion if exposed to flame. Always remove the negative ground first and replace it last.
Do not overfill battery.
Electrolyte may overflow and damage paint, wiring or structure. When cleaning the battery, use soap and water. Be careful not to get soap and water into the battery. Clean the battery terminals with a solution of four parts water and one part baking soda when they become corroded.
WARNING: Shorts caused by battery terminals or metal tools touching metal tractor components can cause sparks. Sparks can cause a battery gas explo- sion which will result in personal injury.
Prevent the battery terminals from touching any metal tractor parts when removing or installing the battery. Do not allow metal tools to short between the battery terminals and metal tractor parts.
WARNING: Incorrect battery cable routing could cause damage to the tractor and battery cables. This can cause sparks which can cause a battery gas explo- sion which will result in personal injury.
Always disconnect the negative (black) battery cable(s) before disconnecting the positive (red) cable(s).
Always connect the positive (red) battery cable(s) before connecting the negative (black) cable(s).
Hydraulic system
The Sport 42/48 is equipped with two
The EZT integrated pump/motor transmissions are sealed for life and do not require any scheduled service.
WARNING: When washing the mower, direct the spray away (especially if using a power washer) from the
601396_0109 |