Hypertec PCI 10/100 TX manual Connecting to the Network, For 10Base-T Ethernet networks

•Turn OFF the power to the computer to prevent any accidental damage.

•Remove your computer's cover (refer to your computer owner's manual).

•Select an available PCI expansion slot which supports Bus Master mode, and remove slot cover. Make a note of the slot number (if one is printed on the motherboard, next to this slot).

•Carefully install the adapter by firmly pressing the card into the slot which you have chosen, and applying even pressure until the adapter is completely seated in the slot.

•Fasten the retaining bracket with the screw on the slot cover. Make sure the adapter is properly aligned.

•Replace the system box cover and fasten it.

Connecting to the Network

This section describes how to connect 10Mbps or 100Mbps network cables to the HyperNet PCI 10/100 series adapter. The backplate of the HyperNet PCI 10/100 series adapter contains one RJ-45 connector. This adapter can use auto-negotiation to automatically determine line operating conditions, such as 10Base-T, 100Base-TX, or a corresponding Full-Duplex mode based on the type of HUB to which it is connected.

For 10Base-T Ethernet networks:

Use Category 3, 4, or 5 UTP cabling.