Anti-Theft System, Handling compact discs

Anti-Theft System

This unit is equipped with a slide-down detachable and mask panel. Panel can be detached and taken with you, helping to deter theft.

1.Press POWER button more than 0.5 seconds to switch off the power of the unit. 2.Press OPEN button to slide down the panel.

3.Hold the panel to pull it out, and then push back the panel bracket. 4.Place the panel into the case and take it with you when you leave the car.

1.Hold the panel so that the panel faces toward you and set the left side of the panel bracket.

2.Press the right side of the panel unit it locks.

3.Check the panel was fasten or not before you operation.

1.Remove the panel and the trim plate.

2.Insert both T-Keys into hole in front of the set until they lock.

3.Pull out the unit.

∙Dirty, scratched or warped discs may cause skip ping or noise.

∙Handle the disc only by the edges. To keep clean do not touch its surface.

∙Discs should be stored in their cases after use to avoid scratches.

∙Do not expose discs to direct sunlight, high humidity, high temperature or dust.

∙Prolonged exposure to extreme temperature can wrap the disc (such as leaving the discs in your car during summertime).

∙Do not stick or write anything on either side of disc. Sharp writing instruments, or the inks used in some felt-tip pens, may damage its surface.

∙DO NOT touch the unlabeled side.

∙DO NOT attach any seal, label or data protection sheet to either side of a disc.

∙This unit cannot play 3-inch ( 8cm ) CDs.

∙Never insert a 3-inch CD contained in the adapter or an irregularly shaped CD. The unit may not be able to eject it, resulting in a malfunction.