8. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and
make sure that all tabs on both mounting brackets secure the adapter in place.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
9. If a three-quarter-length adapter is installed in expansion slot 1 on the
riser-card assembly, remove it. You can replace it with a half-length adapter if
you choose to do so.
10. Carefully align the riser-card assembly with the guides on the rear of the
server and with the riser-card connectors on the system board; then, press
down on the assembly. Make sure that the riser-card assembly is fully seated
in the riser-card connectors on the system board.
PCI-X slot
Power cable
11. If the riser-card assembly is an optional PCI-X riser-card assembly in the
server, reconnect the riser-card power cable to the riser-card assembly.
Note: If you have to remove the Remote Supervisor Adapter II SlimLine, spread
the mounting bracket retention latches as you lift the Remote Supervisor Adapter II
SlimLine, to disconnect it from the system board; then, lift it out of the server. You
can press the middle of the mounting bracket toward the back of the server to
spread the retention latches.
See the documentation that comes with the Remote Supervisor Adapter II SlimLine
for information about installing the firmware and configuring the adapter. Create a
backup copy of the configuration so that if you have to replace the adapter in the
future you can restore the configuration.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 38.
Installing a hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
Attention: To avoid damage to the hard disk drive connectors, make sure that the
cover is in place and fully closed whenever you install or remove a hard disk drive.