IBM manual 56

Symbol	Color	Meaning
	Green	Computer	is
		powered	on

How	to Run	the	Diagnostics
Use either		the	TrackPoint II or III or		the	cursor mov
to	interact	with	the	tests. The Enter key	works	the same
as	selecting	the	OK	icon to reply OK.

1.Press and hold the F1 key; then power-on the computer. Hold the F1 key down until the Easy-setup screen appears.

2.SelectTest and press Enter.

3.

Select a

device

and

press Enter

to run

the

test.

4.

The

test

progress

screen

appears.

5.

OK

appears

when

the

test

ends without

any

errors.

6.

Start

theAdvanced Diagnostic

test

by

pressing

Ctrl +A

on

the

basic

diagnostic

menu

screen.

7.SelectTool to install the tools.

8.Select a device, pressspace thekey, and install the

tool. Multiple devices can be selected by repeating this step.

A √ mark	appears for the	selected device.
9. SelectOK	and press Enter	if the selection is OK.

10.Select a device and press Enter to start the tests.

11.SelectTest All to test all devices.

12. SelectLoop		Test	to	loop tests.
A	loop	option	menu	appears in which a device loop or
all	loop	can	be	selected. Select a device and	press
thespace		key to select a device. Repeat this step t
select multiple devices. Press Enter to start the
diagnostic loop. If no device is selected, all					device
tests are looped.

13.To exit the loop, keepCtrl +pressingPause until the test exits.

Error	Log
Diagnostic		errors are printed on the	printer that is	atta
to	the parallel port when the error		is detected. The	er
also	logged	in the system memory.

Do the following to display the errors.

1.	End the test, if it is			running.
2.	PressCtrl +A	to	select the	advanced		diagnostic	mode.
3. PressCtrl +E .
4.	The error	log	appears.
5.	To exit the screen, select				the cancel icon		or press
	Esc.
The	error log is not saved when system power is
powered-off.
			ThinkPad	340x	(IBM	2610)45