Image Setup for DOS
If the monitor is in sleep mode, it may automatically
turn off while you are waiting for it to warm up. If this happens, turn off the monitor and turn it on again after a few seconds.
If you are using
typing CHEV US and pressing ENTER at the command prompt.
The size and diversity of the dot pattern varies with the
screen resolution.
To set up the monitor automatically in DOS, do the following:
1.Turn on the monitor first; then turn on the computer.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is displayed, check:
•that the video interface cable is connected properly.
•the correct video adapter card is installed.
•the correct supported display mode is selected for your computer.
2.Wait approximately 15 minutes, until the monitor warms up.
3.Insert the User’s Guide and Installation Files CD into the computer CD- ROM drive.
4.Display the command prompt screen of the DOS
5.Type d:\ (change the drive letter to match your
6.Type TESTPAT and press ENTER.
7.Select from the screen the number for the color or text mode you want to set up.
8.Select from the screen the number for the video mode you want to set up. You can repeat this process for as many of the color and video modes as you need.
9.When the dot pattern appears, press the Image Setup ( 
) button at the bottom of the monitor. This activates the IMAGE SETUP ( 
) procedure, which will optimize the display settings with the provided dot patterns.
The screen will momentarily turn black while auto adjustment proceeds.
10.When finished, the Auto Adjustment menu disappears and the screen returns to a normal display.
11.Press the ESCAPE key to exit the test pattern program.
12.Type EXIT at the command prompt to return to Windows.
If you use other operating systems, perform the appropriate Image Setup ( 
) for those systems using instructions given in "Image Setup ( 
) for
Windows 95, Windows 98, Windows NT, Windows 2000, Windows ME, Windows XP on page 13".
12
