14
Manual Setup
If the monitor is in power
saving mode, it
might automatically turn off
while you are waiting for it to warm
up.
Manual setup is not required when using digital input.
Normally, you can complete the setup procedure using AUTO SETUP;
however, if your screen image is still distorted after you perform AUTO
SETUP or the Installation CD does not run on your system, perform MANUAL
SETUP.
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen then go to
windows shut down mode.
3. Press the OSD Enter button MENU at the bottom of the monitor to
display the initial OSD menu.
4. Use the < or > button and MENU to select Image Setup then adjust
clock or Focus
(a) "Clock" (pixel frequency) controls the number of pixels scanned
by one horizontal sweep.
If the frequency is not correct, the screen shows vertical stripes
and the picture does not have the correct width.
(b) "Focus" adjusts the Phase of the pixel clock signal. With a wrong
phase adjustment the picture has horizontal disturbances in light
picture.
5. Use the < or > button to manually adjust and optimize the screen
quality. Save by pressing the Exit button AUTO once and press 2
more times to exit the OSD menu.
You have completed monitor setup.