ICOM-200 / 201

Serial Interface
As a standard the ICOM-200 and ICOM-201 have two serial interfaces. From
these the port Ser0 can by choice be configured as RS232 or RS485
interface. The port Ser1 always is a RS232 interface. In PC mode this port is
used for downloading the program into the ICOM 200/201. In Run mode it can
be used as a usual RS232 interface. 2
Detailled information about the serial interfaces can be read after in the
BASIC-Tiger® „Device driver“ manual.

RS232

Serial port 0 can be configured as RS232 interface with three easy steps:
Remove IC12 from its socket
Please IC3 (MAX232) into the appropriate socket
Set the 4-channel DIP switch S1 to RS232.
Attention: Never place IC3 and IC12 at the same time, as this could
lead to destruction of port 0 !!!
Wilke Technology GmbH • 0241/918 900 • http://www.wilke.de/ • support@wilke.de 2-9