Icom IC-V85, IC-V85-T - page 37

24
5
REPEATER OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
DDTone information
Some repeaters require different tone system to be accessed.
DTMF TONES
While pushing [PTT], push the desired DTMF keys ([0]–[9],
[A], [B], [C], [D], [#] and [✱]) to transmit DTMF tones.
•[✱]transmits tone “E,” [#] transmits tone “F.”
•The transceiver has 16 DTMF memory channels (p. 32).
1750 Hz TONE
While pushing [PTT], push [YY]or [ZZ]to transmit a 1750 Hz
tone signal.
✔Convenient
Tone scan function:When you don’t know the subaudible
tone used for a repeater, the tone scan is convenient for de-
tecting the tone frequency.
Push [FUNC], then push [
T . SCAN ](3) to start the tone scan.
• Push [CLR] to cancel the scan.
• When the required tone frequency is detected, the scan pauses.
■Repeater lockout
This function helps prevent interference to other stations by
inhibiting your transmission when a signal is received. The
transceiver has two inhibiting conditions, repeater and busy.
qWhile pushing and holding [YY]and [ZZ], turn the power ON
to enter INITIALSET MODE .
wPush [YY]or [ZZ]several times until “RLO” appears.
eRotate [VOL] to select the repeater lockout function to
“RP,” “bU” or OFF.
•“RP”:Transmit is inhibited when a signal with un-matched sub-
audible tone is received.
•“bU”: Transmit is inhibited when a signal is received.
rPush [✱ ENT ](or [CLR]) to exit INITIALSET MODE .
USING
INITIAL SET MODE