iHome manual Model iB12, fitness earbuds With clip-on LED safety flasher + cordwrap

Model: iB12

fitness earbuds

with clip-on LED safety flasher + cordwrap

Using Your iHome Headphones

The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear and the “R” earpiece in your right ear for proper fit and best sound. If the earpieces are inserted incorrectly they will not fit properly in your ears and the sound quality will not be satisfactory. For added stability the cables of these ear buds should be looped over your ears as shown in the following illustration.

NOTE: Your iB12 headphones are supplied with three different size silicon tips (S-M-L) for maximum comfort and to seal out unwanted noise. The “M” (medium) size tips were installed at our factory. If you find that the installed tips are too small or too large for your ears, you may remove them and replace

them with the larger or smaller size accessory tips. To replace the tips simply pull them off the earpieces. To install different size tips, push them on to the

earpieces and make sure they are fully seated on each earpiece so that they do not come off when you remove the earpiece from your ear. If one of the tips remains in your ear when you remove the headphones, remove the tip carefully and avoid pushing it further into your ear canal. Seek medical assistance if one of the tips becomes lodged in your ear and you are unable to remove it.

Connect the headphone plug to the headphone jack of your music player. Be sure that the plug is fully inserted into the jack. If the plug is not fully inserted you may only hear sound from one earpiece.

To protect your hearing, always start listening with the volume control of your music source set to a low level and then gradually increase the volume to a comfortable listening level.

LED Safety Flasher

Your iHome iB12 Ear Buds are supplied with a LED safety flasher that includes a convenient belt clip and an integrated cord wrap to keep your cables tangle free. Remove the battery pull tab before use.

Press the Mode Button on the front panel to turn the flasher on and cycle through the 3 operating modes as follows:

First press – LED’s flash rapidly Second press – LED’s flash slowly Third press – LED’s ‘On’ continuously Fourth press – LED’s ‘Off’

Replacing Batteries

Mode Button

Press here to open belt clip

Slide-out
Cord Wrap	Belt Clip

Battery

Compartment

Two CR1625 batteries that were installed at our factory should provide sufficient power for up to 96 hours of continuous operation. When the lighting effect begins to dim or no longer turns ‘On’ you should replace the batteries as soon as practical.

+

+

LITHIUM BATTREY

CR1625 -

3V

- -

+

Remove the battery	To open, unscrew center screw
pull tab before use	only and pull out the batteries tray

Install two fresh CR1625 batteries in the battery tray as shown above