iHome manual Installing/Replacing iH55 Backup Batteries, Using The Remote Control Unit

Installing/Replacing iH55 Backup Batteries

The iH55 uses a backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Battery Low Icon located on the left of the display is flashing, it is time to replace the backup batteries. Please make sure the AC adaptor is connected, otherwise all settings may be lost during battery replacement.

Open the battery compartment cover located on the bottom of the unit. Insert 2 “AA” batteries as indicated. We recommend the use of alkaline batteries for longer life.

Batteries information:

•Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) batteries.

AA

AA

Using The Remote Control Unit

The Remote Control controls basic functions on the iH55 and certain iPod® functions when the iPod® is docked in the iH55. For best results, aim the remote control towards the grille at the lower right-hand corner of the display.

Power On/Off Button	Turns iH55 ON or OFF or resets alarm when alarm is sounding
iPod Play/Pause Button	Selects iPod and plays track. In play mode, press to pause
Button	Skip to previous or next track when iPod is playing, or
Button	HOLD to scan current playing track. In radio mode, press
	to tune stations. HOLD to scan radio stations.
Volume + Button	Raises volume level
Volume _ Button	Lowers volume level
AM/FM Select Button	Selects AM or FM radio band
Radio Button	Selects Radio function
Snooze/Dimmer Button	Snooze mode when alarm sounds, otherwise dims display

Install/Replace the Remote Control Battery

The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, replace the battery with a new one.

1.The battery door is located on the back end of the unit.

2.Squeeze notched tab A while pulling battery door latch B to release the battery door latch and take out the battery holder.

3.Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of the battery) is correct.

4.Replace the battery holder back in the remote control.

NOTE: PLEASE DISCARD BATTERIES PROPERLY

A

Battery door latch

B

5