iHome manual Using iH64, Charging Your iPod, Listening to Your iPod

Using iH64

Install iPod Insert

Your iH64 comes with inserts to ensure your iPod fits properly in the dock. To place an insert:

1.Select the insert for your iPod (see table on page 1).

2.Gently press the iPod insert into the dock.

3.Carefully place your iPod into the dock. The iPod must not be in a case or “skin”.

Connect Speakers

Important: You must turn off the iH64 before connecting or disconnecting speakers!

1.Power off iH64.

2.Connect the right speaker to the speaker jack on the back of main unit.

3.Connect the left speaker to the speaker jack on the back of right speaker.

Install iPod Insert

Install AC Adaptor

Connect the AC adaptor cable plug into the jack on the back of the main unit, then plug the AC adaptor into the wall outlet.

This AC adaptor is for use with the iH64 only. To avoid damage, do not use other adaptor with the iH64.

Install/Replace Battery

1.Open the battery compartment cover located on the bottom of the unit.

2.Insert 4 “AAA” batteries, checking that the polarity (the + and – ends of the batteries) matches the drawing inside the battery compartment. We recommend the use of alkaline batteries for longer life.

3.Close the compartment cover.

Batteries information:

•Do not mix old and new batteries.

•Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.

•Make sure you dispose of batteries properly (see your local regulations).

Note: The iPod does NOT charge when the iH64 is operating on batteries.

Install batteries

Charging Your iPod

Note: Please make sure you are using the correct insert for your iPod (see Install iPod Insert) and that it is properly docked into the iH64.

1.While your iPod is docked in the unit and the unit is connected to AC power, it recharges until fully charged. iPod will not be overcharged. Note that other non-docking iPods will NOT charge. Your iPod will NOT charge when the unit is running on battery power.

Listening to Your iPod

1.Dock the already playing iPod. The iH64 will automatically turn on and you will hear the music playing from your iPod. Note: If the volume of the song/music playing is too low on the iPod itself, iH64 may not detect iPod is in play mode. Press the Power Button on the main unit once to play your iPod.

2.When the iPod is docked and in standby mode, press the Button on the iH64 and then press Play/Pause on your iPod to play it. The blue LED Power indicator will stay on to show the power is on.

3.Press Play/Pause on your iPod to pause play; press again to resume it.

4.	Press the	and Button on the iH64 to adjust the system volume.
5.	Press Button to turn iH64 and iPod off.

3