��

��

 

��

Battery Installation

New 2g iPod nano

NOTE:

FOR BEST SOUND, turn Sound Check ON in your iPod Settings menu

NOTE: ADJUST iPod

VOLUME TO AVOID

DISTORTION

Release Button

Power Indicator

NOTE: UNIT DOES NOT CHARGE iPod nano

Mode Button

iPod nano switch

Using the iHM1

Thank you for purchasing the iHM1, the speaker system for your iPod nano. Designed specifically to work with your iPod nano, this system provides high quality audio and that invites your music to come out and play.

Please read the instructions carefully before operating the unit and keep for future reference.

Installing/Replacing Batteries

1.Open the battery compartment cover located on the back of the unit.

2.Insert 3 “AA” (LR6) batteries, checking that the + and – ends of the batteries match the drawing inside the battery compartment. We recommend the use of alkaline batteries for longer life.

3.Close the compartment cover.

Battery information:

Do not mix old and new batteries.

Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.

Make sure you dispose of batteries properly (see your local regulations).

iPod nano switch (located on bottom of unit):

Default setting is for the new 2g iPod nano.

If you have an original 1g iPod nano, slide the switch to the left position.

Inserting/Removing iPod nano from the unit

1.Slide your iPod nano into the unit as shown. Please make sure the iPod nano is fully docked into the unit before turning on power on the unit.

2.To remove your iPod nano, push the “Release” button down. The iPod nano will pop up and you can tilt it into the palm of your hand.

Listening to your iHM1

1.Turn on your iPod nano and set desired volume.

2.Switch the mode button located on the right side of the unit to On or to SRS TruBass if you want more bass.

3.Because audio tracks are mastered differently, you may notice discrepancies in volume from song to song.

For best sound, turn Sound Check ON in your nano’s Settings menu.

4.Remember to turn unit OFF when not in use to save batteries. To extend battery life, play unit without SRS TruBass feature.

Maintenance

Place the unit away from sources of direct sunlight or excessive heat.

Protect your furniture when placing your unit on a natural wood and lacquered finish.

Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine, thinner or similar materials can mar the surface of the case.

Page 2
Image 2
iHome warranty Using the iHM1, Maintenance