iHome ihome Using Bluetooth with the iBT88, Using the iBT88 with Aux Devices, Charging the iBT88

Connect 3.5mm audio cable

Device must be

within 30 feet (9.14 meters)

Bluetooth Mode

Left Speaker

Right Speaker

Using Bluetooth with the iBT88

•Plug one end of the included 3.5mm audio cable into the speaker out jack on the Right Speaker and the other end into the speaker in jack on the Left Speaker.

• Slide the Off/Bluetooth/Aux Switch (		) on the Right Speaker
to the Bluetooth position ( ). The light	will	flash blue as the speaker

attempts to auto-link with the last previously linked unit in range (30 feet). If no device is found within 10 seconds, the light will flash blue and red to indicate pairing attempt.

• Place your audio device in Bluetooth mode (often found in the

device’s Settings or Tools menu) and make it “discoverable”. “iHome

iBT88” should appear on your device. If “Not Paired, “Not

Connected” or similar message appears, select “iHome iBT88” to

connect.

• Once paired, the light will glow solid blue and a confirmation beep

will sound. If pairing is not successful, turn the power OFF on the

Right Speaker and repeat pairing procedure.

• To listen to Bluetooth audio, make sure the Right Speaker is in

TROUBLESHOOTING

•If there is no sound coming through speaker, try turning the speaker OFF, then ON again

•ALWAYS connect audio cable

BEFORE turning speaker ON

mobile phone PSP iPod MP3/MP4

PC

	Off/Bluetooth/Aux Switch
	LED
Speaker In	Speaker Out	Charging/aux-in

3.5mm audio cable

3.5mm audio plug

Micro USB plug

Standard

USB plug

Bluetooth mode ( ) and the Left Speaker is connected.

• Control Bluetooth audio from your device.

Remember to turn off the speaker and your device after listening.

NOTE: When unit is charging, the blue light will appear magenta.

Using the iBT88 with Aux Devices

•Plug one end of the included 3.5mm audio cable into the speaker out jack on the Right Speaker and the other end into the speaker in jack on the Left Speaker.

•Connect the stereo 3.5mm audio plug on the combination cable to the headphone jack or line-out of any audio device and connect the micro-USB plug into the charging / aux-in jack on the Right Speaker.

• Slide the Off/Bluetooth/Aux Switch (	) switch on the Right
Speaker to the aux position. The blue power light will come on.

•Press play on your audio device and adjust its volume to listen to audio.

Remember to turn off the speaker and your device after listening.

Charging the iBT88

The iBT88 is powered by a rechargeable battery in the Right Speaker. When the light flashes red, or if you start to notice sound distortion at higher volumes, it's time to recharge the battery.

•Connect a micro-USB plug to the input jack on the Right Speaker.

•Connect the larger USB plug to a powered USB port, such as that on a computer. The light on the speaker will turn to solid red while charging and turn off when fully charged.

Note: you can continue to listen to the speakers while the Right

Laptop

Aux-in Mode

Combination cable

Charging the iBT88

Speaker is charging.

The rechargeable battery in your speaker can only be replaced by iHome Consumer Repair Department.