Alarm Operation

The iP21 Home System for iPhone/iPod features “Sure Alarm”. If a power failure occurs or the AC adaptor is accidentally disconnected, the unit will change to buzzer alarm to wake you up (provided you have installed backup battery).

This unit also features Gentle Waking, which gradually increases the volume of whatever alarm you set.

NOTE: TO WAKE TO iPhone/iPod, YOUR iPhone/iPod MUST BE PROPERLY DOCKED AND OFF (NOT IN PLAY MODE) OR NO ALARM WILL SOUND.

Setting the Alarm Time

1.Press and hold the Button for 2 seconds until the display flashes. Press the Hour Button until the desired alarm hour is displayed. Next, press the Minute Button to set the desired alarm minute.

Remember to set the correct AM or PM if you are using 12 hour clock format.

2.Press the Button again to exit the setting mode. You should hear 2 beeps indicating the alarm is set.

Note: Once you set the alarm time, the alarm will be automatically armed, indicated by the Alarm Icon. To disarm the alarm,

press the Button. The Alarm Icon will disappear and the alarm will not sound at the set time.

Note: Make sure to adjust volume level for comfortable wake up volume

4.When the alarm is sounding, the Alarm Icon will flash.

To snooze during the alarm, press the Snooze/Dimmer Button. The alarm will be silenced for 9 minutes, then come on again.

To turn the alarm off, press the Button. The alarm will come on again the next day at the same time.

5.If the alarm is not turned off after it sounds, it will play for approximately one hour then turn off automatically. This cycle will repeat every 24 hours unless the controls are changed.

Note: Please make sure your iPhone/iPod has enough songs to play for one hour, otherwise please set the iPhone/iPod repeat mode to ON.

Note: If there is no iPhone/iPod present or there is no music detected on the iPhone/iPod at alarm time, the iP21 will automatically switch to buzzer alarm.

6

Page 9
Image 9
iHome IP21 manual Alarm Operation, Setting the Alarm Time