I N S T A L L A T IO N
CAMERA TRAY____________________________________________________________
The camera mounts to the tray which extends from the back plate of the housing DO NOT remove the tray from the back plate The camera strap MUST be positioned underneath the camera tray as noted below
Remove camera strap from front loop on the camera Open the camera LCD screen
Place the camera against the stabilizing pins on the tray Secure camera with the tripod mounting bolt The camera should fit easily on the tray and should be parallel with the sides of the tray
Loop the camera strap underneath the camera tray and attach the open end of the strap around the spring pin on the housing back
Press the LCD screen against the shade on the back
Camera
Front Loop
Flap Open
Camera Strap
Mounting Tray |
| Spring Pin |
|
Remove the camera strap from the front loop on the camera
Camera
Front Loop 
Mounting
Tray
Flap Open
Camera Strap
Spring Pin
Loop the camera strap underneath the camera tray and attach the open end of the strap around the spring pin on the housing back with the flap open
IN S T A L L A T IO N c o n t in u e d
INSERTING THE CAMERA_________________________________________________
Check that the clean oring is properly positioned on the lip of the clear back plate Place the lid snaps in the open position
Once the camera is mounted to the tray and the camera strap is secured underneath the tray pull the housing controls out to provide clearance for the camera Align the back plate with the clear housing and slowly place the back plate against the housing
DO NOT force this installation; if the controls are out of the way and everything is lined up properly the camera and tray will fit easily inside Make certain that the tray is completely in the housing The front should be flat against the housing and NOT tilted on one side
HOUSING CONTROLS_____________________________________________________
Slide the housing controls back in place making sure they properly align with the camera functions Fasten the opposite lid snaps at the same timeDO NOT fasten one at a time
Operate each control to see how it works with the camera Some controls such as startstop will be used frequently Other controls may seldom be utilized Refer to your camera owners manual for the proper function of each camera control Look thru the back to be sure that you can see into the viewfinder
When using the housing controls especially the startstop DO NOT use excessive force because you could damage the camera
CAUTION
Remove the lens cap and cord f rom the cameraOtherwisethe cord may
interfere with the housing seal
If the housing controls are not properly positioned they could interfere with the housing seal
IKELITE UNDERWATER SYSTEMS
West rd Street • PO Box • Indianapolis IN USA •
Email: ikelite@ikelitecom • wwwikelitecom
